B - Before D - During A - After W - Weekly M - Monthly Item Interval Item to Be Procedure Check for and have repaired or Equipment is Not Ready/Available No. B   D   A  W  M    Inspected adjusted as necessary If: TM 5-3895-370-14&P Table 2-2.  Operator Preventive Maintenance Checks and Services - CONT. NOTE: Within designated interval, these checks are to be performed in the order listed. REAR OF DISTRIBUTOR - CONTINUED 19 Hand Winches Inspect winches for obvious Wire rope is broken or winch damage and wire rope for fraying does not operate. or kinks that may cause rope to break. LEFT SIDE OF DISTRIBUTOR 20 Torch Assembly Check for proper operation and Torch assembly is damaged or filled tank (para 2-25). otherwise inoperable. 21 Personnel Safety Check safety chain for damage and Safety chain will not operate Chain and proper operation.  Check handrail correctly. Handrail for looseness or missing fasteners. 22 Hydraulic Motor Inspect for leakage. Class III oil leak is present. 23 Inlet/Outlet Port a. Visually inspect outside of a. Class III bituminous Strainers inlet/outlet port strainers for material leakage is present. signs of leakage. b. Inspect inside of strainers for b. Gasket missing or damaged. foreign matter and missing or damaged gasket (para 3-13). 24 Quick a. Check quick disconnects and a. Quick disconnects and Disconnects wire locks for proper operation wire locks not operating (para 2-16). properly. b. Check quick disconnects for b. Gaskets damaged or not missing or damaged gaskets.   present. 25 Bituminous a. Inspect hoses for cuts, tears, a. Hoses damaged or defective. Hoses kinks, or worn surfaces. b. Remove dust covers and check b. Hoses contain obstructions. inside hoses for blockage. 26 Left Wheel Hub Inspect for leakage.   Class III oil leak is present or fill plug missing. 2-11