TM 5-3895-370-14&P
b.
Disassembly.
NOTE
Matchmark head and casing before
disassembly
to
ensure
correct
assembly.
(1)
Remove eight nuts (1) from head (2).
WARNING
Head weighs 113 lbs (51 kg). Two
personnel are required to remove
assembly. Failure to do so may
result in injury to personnel.
(2)
Install two jacking screws (7/16 x 2 1/12 14
UNC) in jacking holes on head (2).
CAUTION
Idler will be attached to head.
Remove head at an angle face down.
Damage will result to idler if idler is
dropped.
(3)
With aid of two assistants, tighten two jacking
screws (7/16 x 2 1/12 14 UNC) on head (2) until
head separates from casing (3), and remove
head from casing.
(4)
Remove and discard head gasket (4) from
casing (3).
(5)
If damaged, remove 24 studs (5) from casing
(3).
(6)
Remove idler (6) from idler pin (7).
(7)
Remove and discard idler bushing (8) from idler
(6).
(8)
Remove dowel pin (9) and idler pin (7) from
head (2).
5-191
