TM 5-3895-370-14&P5-53.BITUMINOUS PUMP REPLACEMENT/REPAIR (CONT).(22)Remove and discard bracket bushing (29) frombracket (17).(23)If damaged, remove five plugs (30) and foursetscrews (18) from bracket (17).c.Cleaning/Inspection.WARNING·Drycleaning solvent (P-D-680) is TOXIC and flammable. Wear protectivegoggles and gloves; use only in a well-ventilated area; avoid contact with skin,eyes, and clothes and do not breathe vapors. Keep away from heat or flame.Never smoke when using solvent; the flash point for type I drycleaning solventis 100°F (38°C) and for type II is 140°F (60°C). Failure to do so may result ininjury or death to personnel. P-D-680 type III is a substitute for types I and II inthis application. The flash point for type III is 200°F (93°C).·If personnel become dizzy while using cleaning solvent, immediately get freshair and medical help. If solvent contacts skin or clothes, flush with cold water.If solvent contacts eyes, immediately flush eyes with water and get immediatemedical attention.·Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa).Use only with effective chip guarding and personal protective equipment(goggles/shield, gloves, etc).CAUTIONDo not allow bearing assembly to spin freely when drying with compressed air;turn bearings slowly by hand. Failure to do so may result in damage to race andballs.(1)Clean all parts with drycleaning solvent and dry with compressed air.(2)Turn outer race of bearing and inspect for roughness.(3)Inspect outer metal of head, casing and bracket for cracks, wear, and other visible damage.(4)Inspect rotor, shaft, idler, idler pin, inner casing and bracket for burrs, nicks or excessive wear.(5)Replace all parts failing inspection.5-194
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
