TM 5-3895-370-14&P
(28)
Install idler pin (7) and dowel pin (9) on head (2).
(29)
Heat idler (6) in a suitable oven at 750 degrees
F (399 degrees C) until idler reaches oven
temperature.
WARNING
Idler retains extreme heat. Wear
protective gloves when installing
idler bushing. Failure to do so will
cause severe burns to personnel.
(30)
Install idler bushing (8) in idler (6).
(31)
Install idler (6) on idler pin (7).
WARNING
Adhesive sealant MIL-S-46163 can
damage your eyes. Wear safety
goggles/glasses when using; avoid
contact with eyes. If sealant contacts
eyes, flush eyes with water and get
immediate medical attention.
(32)
If removed, apply sealant to one end of 24 studs
(5).
(33)
If removed, install 24 studs (5) on casing (3).
(34)
Install head gasket (4) on casing (3).
NOTE
Alinement stud is located near matchmark shown.
(35)
With aid of two assistants, aline matchmarks and install head (2) and eight nuts (1) on casing (3). Tighten nuts
100 to 110 lb-ft (136-149 Nm).
5-199