SERVICE MANUALInsert the spring into the cupped or closed end ofthe filter element. Position the open end of thefilter element over the guide and force the springinto place in the recessed area of the reservoirneck.8.Replace reservoir gasket and sealing washerson inside of reservoir (Figure 8) and installreservoir. Seat reservoir by placing a woodblock against rear of reservoir and rapping blockwith a hammer.Fig. 8 Sealing Washer Location1Reservoir2Sealing Washers9.Install reservoir retaining nuts and tighten tospecified torque.10.Reinstall pump assembly on vehicle. See IN-STALLATION AND REMOVAL section of thismanual.PUMP SHAFT OIL SEAL REPLACEMENT (PUMPASSEMBLED)1.Remove pump assembly from vehicle. SeeINSTALLATION AND REMOVAL section of thismanual. Remove mounting flange (gear drivenpump only) and coupling (if equipped).2.Place Seal Remover SE-2839 over pump shaft.Apply downward pressure on top of tool andscrew tool into seal material until firmly seated,Figure 9.3.Thread tool bolt into tool and against top ofFig.9 Seating Seal Remover Tool1Seal Remover SE-2839Fig. 10 Removing Shaft Seal1Seal Remover SE-28392Pump Shaft Oil Seal4.Lubricate new shaft seal with same type of pumpshaft until tool and seal are drawn out fluid asused in pump, then slide seal over shaft withmetal side of seal upward.CTS-4027 - Page 11
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
