SERVICE MANUALSERVICERefer to Figure 4 to aid service procedures.OIL FILTER REPLACEMENT1.Remove pump from vehicle. See INSTALLA-TION AND REMOVAL section of this manual.Drain oil from reservoir.2.Place pump in a bench vise using the mountingflange (gear driven pump) or mounting bracket(belt driven pump) to hold pump.IMPORTANTDo not clamp vise on pump housing or reservoir,3.Mark position of reservoir on pump housing toprovide proper location during reassembly.4.Remove reservoir retaining nuts, Figure 5.Fig. 5 Remove Retaining Nuts1Reservoir Retaining Nuts5.Remove reservoir by rapping the side of thereservoir with the hand until the reservoir rotatesslightly on the pump housing.IMPORTANTDo not pry on reservoir flange to removereservoir6.To remove filter element, insert a screwdriverbehind the spring and pry the spring out, Thefilter element can then be removed. There isalso a loose filter element guide thatfits over the end of the return tube on the insideof the reservoir, Figures 6 and 7. Clean interiorof reservoir and components with clean solventand air dry.7.To install filter element, slide the guide over theend of the return tube with the long end of guidetoward reservoir wall. Some units are equippedwith a spacer which should be placed over thereturn tube prior to installing the guide.Fig. 6 Filter Location1Reservoir2Oil Return Inlet Tube3Filter Element4Filter GuideFig. 7 Filter Components1Filter Guide2Filter3SpringCTS-4027 - Page 10
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
