TM 5-3895-370-14&P
5-19. FLYWHEEL REPLACEMENT (CONT).
(3)
Remove eight screws (6) and washers (7) from
flywheel (8).
WARNING
Use caution when removing flywheel.
Ensure that engine block is secured
or injury to personnel may result.
(4)
With aid of assistant, stand against housing (5)
and alternately tap on flywheel (8) through
access hole and starter hole. Do this until top
part of flywheel is loosened.
(5)
Hold top part of flywheel (8) place fingers
through center hole, and remove flywheel (8)
from flywheel housing (5).
b. Installation.
(1)
With aid of assistant, install flywheel (8) and lean
against flywheel housing (5) to prevent flywheel
from falling out.
(2)
Install eight washers (7) and screws (6).
NOTE
It
may
be
necessary
to
hold
crankshaft to tighten screws.
(3)
Tighten eight screws (6) 101 lb-ft (137 Nm) in
sequence shown.
5-44
