TM 5-3895-370-14&P
d. Assembly.
NOTE
Lubricate all seals with hydraulic fluid
prior to installation.
(1)
Install shaft face seal (1) using shaft face seal
installation tool in bearing house (2).
(2)
Install key (3) on shaft and bearing assembly (4).
NOTE
Arbor press may be required to install
shaft
and
bearing
assembly
in
bearing housing.
(3)
Install shaft and bearing assembly (4) in bearing
housing (2).
(4)
Install seal (5) in bearing housing (2).
(5)
Install backup ring (6), shaft seal (7), and dust seal (8) in mounting flange (9).
(6)
Install mounting bracket (9) on bearing housing (2).
(7)
Install eight screws (10).
(8)
Install bearing housing (2) and mounting flange (9) in vise.
(9)
Tighten eight screws (10) to 250 ± 10 lb-in (28 + 1 Nm) in sequence as shown.
5-167
