TM 5-3895-370-14&P
5-48. HYDRAULIC MOTOR REPLACEMENT/REPAIR (CONT).
NOTE
Reposition motor in vise so that shaft
and bearing assembly is down.
(10)
Install seal (11) on bearing housing (2).
NOTE
Install drive with longer splined end
of
drive
in
shaft
and
bearing
assembly.
(11)
Install spur gear (12).
(12)
Install alinement studs.
(13)
Install two preformed packings (13) on gerotor
(14).
(14)
Aline case drain hole and pressure relief hole on
gerotor (14) with case drain hole and pressure
relief hole on bearing housing (2) and install
gerotor.
5-168
