TM 5-3895-370-14&P
NOTE
Timing line indicates the largest open
pocket in gerotor.
(15)
Mark a timing line on outside of gerotor (14).
(16)
Install valve drive (15) in gerotor (14).
(17)
Install seal (16) on valve plate (17).
(18)
Aline case drain hole in valve plate (17) with
case drain hole in gerotor (14) and install gerotor
on valve plate.
(19)
Install valve (18) on valve plate (17) as follows:
(a)
Locate valve plate (17) opening which is in
line with timing line on gerotor (14) and
mark a timing line on valve plate.
(b)
Locate side opening on valve (18) which
can be alined with timing line on gerotor
(14) and valve plate (17). Install valve on
valve plate.
(c)
Rotate valve (18) clockwise to engage
spline teeth of valve drive (15).
(20)
Install two springs (19) into holes located inside
valve body (20).
(21)
Install seal (21) and preformed packing (22) on
valve body (20).
(22)
Assembly balance ring assembly (23) as follows.
(a)
Install inner seal (24) on balance ring (25).
(b)
Install outer seal (26) on balance ring (25).
(23)
Install balance ring assembly (23) in valve body
(20).
(24)
Aline case drain hole in valve body (20) with
case drain hole in valve plate (17) and install
valve body on valve plate.
5-169
