TM 5-4320-301-13&P
TM 08936A-13&P/1
CHAPTER 5
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
Section I
REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
5-1. COMMON TOOLS AND EQUIPMENT. Refer to the Modified Table of Organization and Equipment
(MTOE) applicable to your unit.
5-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. NO special tools, TMDE, or support
equipment are required for the FAWPSS system.
5-3. REPAIR PARTS. Repair parts are listed in Appendix C of this manual.
Section II.
DIRECT SUPPORT MAINTENANCE TROUBLESHOOTING TABLE
5-4. GENERAL.
a. This section provides information in diagnosing, and correcting unsatisfactory operation or failure of
FAWPSS. Each malfunction is followed by a list of probable causes and actions to take to remedy the
malfunction. You should perform the tests/inspections and corrective actions in the order listed.
b. This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions.
If a malfunction is not listed or is not corrected by corrective actions, notify your supervisor.
Table 5-1. Troubleshooting
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. 2-INCH VALVE ASSY
Inspect for cracked or dented female and male quick-disconnect coupling.
Replace with female or male quick-disconnect coupling. Refer to direct maintenance
procedures 5.5.
5-1
