TM 5-4320-301-13&P
TM 08936A-13&P/1
NOTE
Only disassemble the parts of the yoke that require repair or replacement.
DISASSEMBLY
a.
Remove setscrews (4) and pins (3) and separate connecting legs (1) from upper legs (2).
b.
Remove screws (6) and nuts (7) and separate the two braces (5) from the connecting legs (1).
c.
If necessary, separate the two braces (5) by removing the cap screws (8) and nuts (9).
d.
Pull cotter pins (13) and remove clevis pins (12) hooks and key rings (11), and chains (10) from connecting legs.
REPAIR
a.
Using the proper tools, straighten any bent legs (1). (2) or braces (5). Weld any minor cracks or breaks that were
detected during inspection. Replace any leg or brace that is damaged beyond repair.
b.
Replace any remaining parts that are damaged or defective.
ASSEMBLY
a.
Attach chains (10), hooks and key rings (11) and clevis pins (12) to connecting legs (1) and secure cotter pin (13).
b.
Connect the two braces (5) and install screws (8) and washers (9).
c.
Connect the two braces (5) to the connecting legs (1) and secure with screws (6) and nuts (7).
d.
Attach the upper legs (2) to the connecting legs (1) with pins (3) and setscrews (4).
4-20.2 Change 8