TM 5-4320-301-13&P
TM 08936A-13&P/1
Section V
ORGANIZATIONAL MAINTENACE
4-13. HOSE ASSYS, REPAIR (CONT).
.
I INSTALLATION
a.
b.
c.
d
e.
PROCEDURES (Contd.)
For reassembly use clamping tool, PN C001 (70847) supplied with the system kit.
Insert coupling half into the hose. Cut a band of strapping that will extend 8 to 10 inches beyond end
of buckle toothed slot.
Hook the band over top of buckle between the prongs (4) bringing other end around hose and through
buckle.
Inseert band end into tool slots. Nose of tool should fit snug against buckle (5).
Apply tension on tool handle and gripper lever and position as required. Tool will self-lock when
proper tension is applied (6).
Band may break if operator releases tension handle before backing
off entire length of bend.
4-19