CYLINDER HEAD & VALVES - CONT - TM-5-3820-256-24-5

CYLINDER HEAD & VALVES - CONT - TM-5-3820-256-24-5_198

CYLINDER HEAD & VALVES - CONT - TM-5-3820-256-24-5_200

TM-5-3820-256-24-5 Drilling System Well Rotary Truck Mounted Air Transportable 600 Feet Capacity Model LP-12 NSN 3820-01-246-4276 Manual
Page Navigation
168

SERVICE MANUAL CYLINDER HEAD & VALVES Section 3 5. Inspect NOZZLE SLEEVE BORE for: grease, oil, scale or rust after removing sleeve. a. Remove nozzle sleeve (2), Fig. 21) with slide hammer (3) and nozzle sleeve puller adapter (1). (See Tool List for tool number). Figure 21. - Removing Nozzle Sleeve 1. Adapter 2. Sleeve 3. Slide hammer b. Inspect and clean bore as necessary. c. Reinstall injection nozzle sleeves as follows: 1. After cleaning bore, apply locite 262 to upper contact surface of sleeve (A) as shown in Fig. 22. Figure 22. - Nozzle Sleeve Contact Points (Installed View) 2. Place nozzle sleeve (2, Fig. 23) in cylinder head bore. Position installing tool (1) in sleeve as shown in Fig. 22. Keep tool centered and tap squarely with brass hammer until sleeve is bottomed in bore. (See Tool List for tool number). Figure 23. - Nozzle Installing Tool Placement 1. Installing tool 2. Nozzle sleeve 3. Tighten nozzle crab bolts to 27 N-m (20-lbf-ft) torque. NOTE: Nozzle sleeves can be installed without removing the cylinder head. CGES-185-3 PRINTED IN UNITED STATES OF AMERICA Page 19

Privacy Statement
Press Release
Contact