ROCKER ARM ASSEMBLY REPLACEMENT/REPAIR (cont)

ROCKER ARM ASSEMBLY REPLACEMENT/REPAIR (cont) - TM-5-3895-370-14P_677

TM-5-3895-370-14P Spreader Aggregate: Towed; 3 Ft Spread FF-8 (NSN 3895-01-329-5096) Manual
Page Navigation
664

TM 5-3895-370-14&P 5-22. ROCKER ARM ASSEMBLY REPLACEMENT/REPAIR (CONT). (4) Measure rocker arm support shaft as indicated. Normal diameter is 0.7456 to 0.7470 in. (18.9382-18.9738 mm). If above or below normal measurement, replace rocker arm support. d. Assembly. NOTE All four rocker arm assemblies are assembled the same way. (1) Loosely install two pushrod adjusting screws (6) and nuts (5). (2) Lubricate shafts of arm support (4) with engine oil. NOTE Intake rocker arm is shorter than exhaust rocker arm. Compare rocker arms to ensure proper installation. (3) Install two rocker arms (3), washers (2), and retaining rings (1). CAUTION Check and ensure that rocker arms are installed in correct locations. Damage will result to engine if incorrectly installed. (4) If removed, install expansion plug (7) in arm support (4). 5-52

Privacy Statement
Press Release
Contact