SERVICE MANUAL REASSEMBLY Section 4 Figure 13.  Basic Setting of S-Plate 1. S-Plate Gauge 9 681 238 904 2. Notch in Gauge 3. Guide Pin 4. Gasket NOTE:  If S-plate gauge 9 681  238  904  is  not  available use   a   depth   micrometer   to   measure   S-plate   setting (distance   to   measure   described   above)   (Figure   14). Basic setting is 21.5 0.2 mm (.847 Figure 14.  Measuring S-Plate Basic Setting (If S-Plate Gauge 9 681 238 904 is not available) 1. Basic Setting 4. Curve Plate 2. Guide Pin 5. Depth Micrometer 3. Gasket 9. Add  shims  under  S-plate  mounting  to  decrease basic setting or remove shims to increase basic setting   (Figure   15).      Check   for   free   travel   of guide pin shaft in S-plate after resetting.  Check to be sure cotter pin has been used to secure pin between rack link and floating lever. Figure 15.  Locating for S-Plate Shim Adjustment 1.  S-Plate 2.  Shim 10. Install     governor     cover     to     housing.          When installing,  apply  small  dab  of  grease  to  floating block to hold hollow end up and note that floating block enters floating lever.  Operate control lever to  facilitate  installation.    Secure  cover  with  six cover screws. 11. Install guide bolt in rear of governor cover.  Apply Loctite  hydraulic  sealant  compound  to  threads before installing. 12. If governor control lever and/or accelerator lever assembly were removed, reinstall at this time as follows: a. Install   woodruff   key   and   governor   control lever on shaft and tighten securely. b. Install  accelerator  lever  assembly  on  shaft (Figure 16) and tighten securely. IMPORTANT ACCELERATOR          LEVER     CAN     BE INSTALLED   IN   ANY   POSITION   AND CAN BE REMOVED AND REINSTALLED AT ANY TIME. GOVERNOR CONTROL LEVER, ONCE HIGH SPEED SCREW HAS BEEN SET, SHOULD  NEVER  BE  REMOVED  AND REINSTALLED WITHOUT RECHECKING HIGH IDLE SPEED. CGES-375 Printed in United States of America Page 6